Modern Design Base Mold Fiberglass Silicone Base Molds SC-E-11
RF garden decoration Roman pier mold garden ancient greek column foundation column mold
- Product Introduction
Foundation column mold use process
1.First , please clean the inner surface of the mould before using it.
2. Start mixing concrete, the ratio of concrete is cement: sand: stone: water = 2:3:1:1.
3. Then pour the mixed concrete into the mold, and then use a rubber hammer to knock a few times at intervals to try to shake out the air bubbles inside the concrete
4. Wait for the solidification, when the hand test along the mouth has become dry, you can start to take off the mold
5. Demould, screw off the screws, remove the silicone film, the finished product will be come out.
How long is the demoulding time of the sculpture mold?
The demoulding time of the sculpture mold is 1-2 days. Let the customer look at the discharge port after finishing, and try it by hand. If the surface is hard, it can be disassembled.
What is the raw material of the sculpture mold?
Silicone + fiberglass, we usually pour plaster or cement into the Foundation column mold, the cement does not heat, so it will not damage the mold.
Hot Tags: modern design base mold fiberglass silicone base molds sc-e-11, China modern design base mold fiberglass silicone base molds sc-e-11 manufacturers, suppliers, Plaster Cornice, Decorative Garden Sculpture, Ceiling Medallions For Chandeliers, Exterior Decoration Mold, Precast Trench Cover Mold, Decorative Ceiling Medallions
