Fiberglass Silicone Modern Base Mold SC-E-09
RF garden decoration Roman pier mold garden ancient greek column foundation column mold
- Product Introduction
Foundation column mold use process
1.First , please clean the inner surface of the mould before using it.
2. Start mixing concrete, the ratio of concrete is cement: sand: stone: water = 2:3:1:1.
3. Then pour the mixed concrete into the mold, and then use a rubber hammer to knock a few times at intervals to try to shake out the air bubbles inside the concrete
4. Wait for the solidification, when the hand test along the mouth has become dry, you can start to take off the mold
5. Demould, screw off the screws, remove the silicone film, the finished product will be come out.
How long is the demoulding time of the sculpture mold?
The demoulding time of the sculpture mold is 1-2 days. Let the customer look at the discharge port after finishing, and try it by hand. If the surface is hard, it can be disassembled.
What is the raw material of the sculpture mold?
Silicone + fiberglass, we usually pour plaster or cement into the Foundation column mold, the cement does not heat, so it will not damage the mold.
Hot Tags: fiberglass silicone modern base mold sc-e-09, China fiberglass silicone modern base mold sc-e-09 manufacturers, suppliers, Eldorado Stone Concrete Silicone Mold, Silicone Old Masonry Mold, Precast Concrete Railing, Flower Breeze Block Mold, Cement Hollow Brick Mould, Plank Wood Imprint Stamp Concrete Mold
