What Is The Correct Installation Method For Gypsum Wire Mold?

Gypsum line as a home wall decoration material, in the decoration is the most common, this issue to introduce you to gypsum wire mold two different installation methods and detailed installation steps. If there is putty on the original wall, remove it until the cement layer is exposed (this is important, otherwise it will cause the plaster line to continue to fall off in the future). Then use glue to mix the sticky powder, adjust as you go, to avoid waste.
You can apply it in spots, but the interval between the two points cannot be, the plaster line must be pressed firmly after being attached at an angle, and then the extruded block of sticky powder is applied to the gap with your fingers, and finally brush the seam of the plaster line with a brush dipped in clean water. First drill two 1 cm holes in the wire groove on the gypsum wire mold, for example, the gypsum line is 2 meters long, drill holes 55 cm in the middle at both ends, and then put them in the position to be installed and draw the hole with a pencil. Take it down, drill the hole with a 1 cm electric drill, and put in a plastic stopper or wooden plug. One holds down the plaster line, one is fixed with self-tapping nails. The gypsum line is easy to break and step on, so the construction loss of the gypsum line is very large, and after installing the gypsum line, it is necessary to paint, so it is not necessary to buy a good quality gypsum line. First draw the position that should be pasted, then the bullet line to find the position, the plaster line for vertical cutting and bevel cutting, and then quickly stick powder and water, and pay attention to rapid use after water, otherwise it will become hard immediately.